alexa Analog Multiplier Based Single Phase Power Measurement
ISSN: 2332-0796

Journal of Electrical & Electronic Systems
Open Access

OMICS International organises 3000+ Global Conferenceseries Events every year across USA, Europe & Asia with support from 1000 more scientific Societies and Publishes 700+ Open Access Journals which contains over 50000 eminent personalities, reputed scientists as editorial board members.

Open Access Journals gaining more Readers and Citations

700 Journals and 15,000,000 Readers Each Journal is getting 25,000+ Readers

This Readership is 10 times more when compared to other Subscription Journals (Source: Google Analytics)

Research Article

Analog Multiplier Based Single Phase Power Measurement

Pandey S1 and Singh B2*

1Krishna Engineering College; Ghaziabad, Uttar Pradesh, India

2Ajay Kumar Garg Engineering College; Ghaziabad, Uttar Pradesh, India

*Corresponding Author:
Singh B
Ajay Kumar Garg Engineering College
Ghaziabad Uttar Pradesh, India
Tel: 0120 276 2841
E-mail: [email protected]

Received Date: April 18, 2016; Accepted Date: April 23, 2016; Published Date: May 19, 2016

Citation: Pandey S, Singh B (2016) Analog Multiplier Based Single Phase Power Measurement. J Electr Electron Syst 5:183. doi:10.4172/2332-0796.1000183

Copyright: © 2016 Pandey S, et al. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.

 

Abstract

Present paper proposes a power measurement technique of a single phase electrical load. The proposed method is a low cost power measurement technique. The load which is taken into consideration is either resistive load such as bulb or inductive load like single phase induction motor. This method is based on a low cost analogue IC (AD633) which does the analogue multiplication of the two input signals. In fact, AD633 is well suited for applications such as power measurement, modulation and demodulation, automatic gain control, voltage-controlled amplifiers, and frequency doublers. In present work AD633 is employed for power measurement. The AD633 output voltage give the multiplication of corresponding current and voltage signals of the load and produces pulsating signal/voltage at the double of the supply frequency. The higher frequency output of AD633 is attenuated by a low pass filer of an appropriate cut-off frequency (90 Hz). The corresponding DC component of the multiplier IC output obtained at the output of the active RC low- pass filter is found to be proportional to the average load power consumed. The output of RC low pass filter was plotted against different values of load using MATLAB code. The linearity of these plots was checked through the linear curve fit and the original plots for the validation purposes

Keywords

Related Subjects

Share This Page

Additional Info

Loading
Loading Please wait..
 
Peer Reviewed Journals
 
Make the best use of Scientific Research and information from our 700 + peer reviewed, Open Access Journals
International Conferences 2017-18
 
Meet Inspiring Speakers and Experts at our 3000+ Global Annual Meetings

Contact Us

 
© 2008-2017 OMICS International - Open Access Publisher. Best viewed in Mozilla Firefox | Google Chrome | Above IE 7.0 version
adwords