Cast Aluminum Composite Obtained by Using Ultrafine Carbon Raw Materials
- *Corresponding Author:
- Al-Qrimli HF
Department of Mechanical Engineering
Curtin University, CDT 250 98009
Miri, Sarawak, Malaysia
E-mail: [email protected], [email protected]
Received Date: November 26, 2014; Accepted Date: January 23, 2015; Published Date: January 31, 2015
Citation: Al-Qrimli HF, Almurib HA, Kumar N, Mahdi FA (2015) Dynamic Analysis of a Straight Bevel Gear Composite Structure. J Material Sci Eng 4:152. doi: 10.4172/2169-0022.1000152
Copyright: © 2015 Al-Qrimli HF, et al. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
The paper presents the casting-deforming technology intended to produce cast aluminum composites and items from them (in-situ technology). In addition the investigation has been made of the effect of mechanical activation of a charge containing these carbon forms as well as of intensive plastic deformation on the possibility of their structure rearrangement and creation of new forms (glass carbon and diamond-like carbon particles) with the aim of their use in in-situ casting technologies.