Matlab Simulation for Generation and Performance Analysis of Gold Codes in CDMA
Lateef AAA, Ayed B, Khalid S, Ali F, Ghazi M and Mahammed KA*
Department of Electrical Engineering, College of Engineering, Al Dawadmi, Shaqra University, Saudi Arabia
- *Corresponding Author:
- Khaleel Anwar Mahammed
Lecturer Department of Electrical Engineering College of Engineering
Al Dawadmi Shaqra University, Saudi Arabia
E-mail: [email protected]
Received Date: April 24, 2017; Accepted Date: May 22, 2017; Published Date: May 29, 2017
Citation: Lateef AAA, Ayed B, Khalid S, Ali F, Ghazi M, et al. (2017) Matlab Simulation for Generation and Performance Analysis of Gold Codes in CDMA. J Biosens Bioelectron 8: 243. doi: 10.4172/2155-6210.1000243
Copyright: © 2017 Lateef AAA, et al. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
In communication, SS plays a vital role in practical application like mobile communication in CDMA because it has advantage like noise immunity. Spread spectrum technique may be a digital pass band technique. Some good codes are used by SS modulation and demodulation scheme0.s. At the channel the signal with noise gets jammed and results in transmission problem. So, this paper depicts PN codes for the development of gold codes with accuracy. These codes ought to be well arranged to the message signal. This sequence which is developed as the spreaded signal for the transmission process in CDMA shall contain the noise immunity property. Received signal from the transmission process is despreaded in receiver. Designed sequence with similar gold codes acclimated to redesign the baseband signal. For the above mentioned process Matlab simulation programming has been adopted.