GET THE APP

Three phase Z-source multilevel inverter system for renewable ene | 55917
Journal of Fundamentals of Renewable Energy and Applications

Journal of Fundamentals of Renewable Energy and Applications
Open Access

ISSN: 2090-4541

+44 1300 500008

Three phase Z-source multilevel inverter system for renewable energy application


International Conference on Renewable Energy and Resources

July 24-25, 2017 Vancouver, Canada

Sanjeevikumar Padmanaban, K M Pandav, S B Mahajan and F Blaabjerg

University of Johannesburg, South Africa
Aalborg University, Denmark

Posters & Accepted Abstracts: J Fundam Renewable Energy Appl

Abstract :

The demand of electricity in upcoming days is rapidly increasing. The optimum solution over this problem can be obtained by using Renewable Energy system (RE-System). Wind energy can be considered as one of the source from renewable energy. Wind is inexhaustible, clean and free source. Wind is normally variable in nature hence the energy generated at turbine end from wind is also with variable output voltage and variable output frequency. These parameters are dependent on wind velocity and direction. The drawback observed in the traditional system is about variable output power. Generally this variable input gets converted to DC supply and further to AC supply using voltage source inverter (VSI). Since the wind energy output is very low and need to connect extra DC chopper circuit at the output of rectifier to boost the voltage before inverter. Z-Source Multilevel Inverter (Z-Source MLI) provides a practical solution to overcome the above mentioned problem. Z-Source MLI consists of less number of components and it is cost efficient. For low power application, wind turbine can be run on single phase AC supply but in case of higher power applications three phase supply is needed. Hence single phase AC supply is transformed to three phase AC supply using Z-Source MLI. The efficient operation is maintained even though low voltage is there due to low wind speed. If there is higher wind speed, gives higher voltage, the system can operates like normal VSI and need not to boost the voltage. The controlling can be done by controlling modulation index. Major roll of this Z-Source MLI is to take care of both input voltage and load variation.

Biography :

Email: sanjeevi_12@yahoo.co.in

Top