alexa Composite bond strength to enamel with self-etching primers.



Author(s): Lopes GC, Marson FC, Vieira LC, de Caldeira AM, Baratieri LN

Abstract Share this page

Abstract This study compared the shear bond strength (SBS) to enamel of five self-etching primer/adhesive systems and one total-etch, one-bottle adhesive system. Sixty freshly extracted bovine incisors were mounted, polished to 600-grit and randomly assigned to six groups (n=10): Adper Prompt Self-Etch (AD), OptiBond Solo Plus Self-Etch (OP), AdheSE (AS), Tyrian (TY) and Clearfil SE Bond (SE) as self-etching systems; and Single Bond (SB) as a total-etch system (control). The respective hybrid composite was applied in a #5 gelatin capsule and light-cured. After 500 thermal cycles (5 degrees C-55 degrees C), the specimens were loaded in shear using an Instron at 5 mm/minute. Mean bond strengths were analyzed with one-way ANOVA, followed by a Duncan's post-hoc test (p 0.05). SBS (mean +/- SD) were: AD=13.0(+/- 2.5); OP=5.6(+/-2.3);AS=12.6(+/-3.7); TY=7.6(+/-2.6); SE=17.6(+/-4.5) and SB=17.9(+/-4.4). ANOVA showed a significant difference at p<0.0001. Duncan's post-hoc test ranked this difference in three homogeneous subsets. Only SE showed similar enamel SBS compared to the total-etch system tested (SB). AD and AS were ranked in the intermediary Duncan's subset, while TY and OP resulted in the lowest SBS. SBS to enamel with self-etching primers may depend on its specific composition.
This article was published in Oper Dent and referenced in Dentistry

Relevant Expert PPTs

Recommended Conferences

Relevant Topics

Peer Reviewed Journals
Make the best use of Scientific Research and information from our 700 + peer reviewed, Open Access Journals
International Conferences 2017-18
Meet Inspiring Speakers and Experts at our 3000+ Global Annual Meetings

Contact Us

© 2008-2017 OMICS International - Open Access Publisher. Best viewed in Mozilla Firefox | Google Chrome | Above IE 7.0 version