alexa Fed-batch bioreactor strategies for microbial decolorization of azo dye using a Pseudomonas luteola strain.
Environmental Sciences

Environmental Sciences

Journal of Bioremediation & Biodegradation

Author(s): Chang JS, Lin YC

Abstract Share this page

Abstract A Pseudomonas luteola strain possessing azoreductase activity was utilized to decolorize a reactive azo dye (C. I. Reactive Red 22) with fed-batch processes consisting of an aerobic cell growth stage and an anaerobic fed-batch decolorization stage. The fed-batch decolorization was conducted with different agitation and aeration rates, initial culture volumes, dye loading strategies, and yeast extract to dye (Y/D) ratios, and the effect of those operation parameters on azo dye decolorization was evaluated. Dissolved oxygen strongly inhibited the azo reduction activity; thus aeration should be avoided during decolorization but slight agitation (around 50 rpm) was needed. With the periodical feeding strategy, the specific decolorization rate (v(dye)) and overall decolorization efficiency (eta(dye)) tended to increase with increasing feeding concentrations of dye, whereas substrate inhibition seems to arise when the feeding concentration exceeded 600 mg dye/L. In the continuous feeding mode, higher initial culture volume resulted in better eta(dye) due to higher biomass loading, but lower v(dye) due to lower dye concentration in the bioreactor. With a volumetric flow rate (F) of 25 mL/h, both v(dye) and eta(dye) increased almost linearly with the increase in the loading rate of dye (F(dye)) over the range of 50-200 mg/h, while further increase in F(dye) (400 mg/h) gave rise to a decline in v(dye) and eta(dye). As the F was doubled (50 mL/h), the v(dye) and eta(dye) increased with F(dye) only for F(dye) < 80 mg/h. The best v(dye) (113.7 mg dye g cell(-)(1) h(-)(1)) and eta(dye) (86.3 mg dye L(-)(1) h(-)(1)) were achieved at F(dye) = 200 mg/h and F = 25 mL/h. The yield coefficient representing the relation between dye decolorized and yeast extract consumed was estimated as 0.8 g/g. With F(dye) = 75 mg/h, the Y/D ratio should be higher than 0.5 to ensure sufficient supply of yeast extract for stable fed-batch operations. However, performance of the fed-batch decolorization process was not appreciably improved by raising the Y/D ratio from 0.5 to 1.875 but was more sensitive to the changes in the dye loading rate. This article was published in Biotechnol Prog and referenced in Journal of Bioremediation & Biodegradation

Relevant Expert PPTs

Relevant Speaker PPTs

Recommended Conferences

Relevant Topics

Peer Reviewed Journals
Make the best use of Scientific Research and information from our 700 + peer reviewed, Open Access Journals
International Conferences 2017-18
Meet Inspiring Speakers and Experts at our 3000+ Global Annual Meetings

Contact Us

© 2008-2017 OMICS International - Open Access Publisher. Best viewed in Mozilla Firefox | Google Chrome | Above IE 7.0 version