alexa Photocatalytic degradation of BTEX using W-doped TiO2 immobilized on fiberglass cloth under visible light.
Materials Science

Materials Science

Research & Reviews: Journal of Material Sciences

Author(s): Weradeach Sangkhun, Laksana Laokiat, Visanu Tanboonchuy, Pummarin Khamdahsag, Nurak Grisdanuraka

Abstract Share this page

W-doped TiO2 were immobilized on fiberglass cloth (FGC). The catalyst possessed small crystallite sizes with a red-shift on an absorption edge. Good dispersion was observed over the immobilized catalyst. The photocatalytic degradation of gaseous BTEX was conducted in a flow reactor under day-light fluorescent. Parameters including gas flowrate, catalyst loading, initial concentration and relative humidity (%RH) were investigated. The prepared catalysts showed higher efficiency than that of TiO2 approximately 18, 3, 3 and 2.5× for benzene, toluene, ethylbenzene and o-xylene, respectively. The condition to achieve 100% BTEX removal was found at 20 min/ml, catalyst loading 0.1 mg/cm2 and 30% RH.

This article was published in Super lattice Microst and referenced in Research & Reviews: Journal of Material Sciences

Relevant Expert PPTs

Relevant Speaker PPTs

Peer Reviewed Journals
 
Make the best use of Scientific Research and information from our 700 + peer reviewed, Open Access Journals
International Conferences 2017-18
 
Meet Inspiring Speakers and Experts at our 3000+ Global Annual Meetings

Contact Us

 
© 2008-2017 OMICS International - Open Access Publisher. Best viewed in Mozilla Firefox | Google Chrome | Above IE 7.0 version
adwords