Design and Theory for Creating Hover BoardPraneet Sah*
Department of Science, Bedi International School, Bareilly, India
- *Corresponding Author:
- Praneet Sah
Department of Science, Bedi International School
E-mail: [email protected]
Received date: August 29, 2016; Accepted date: September 21, 2016; Published date: September 27, 2016
Citation: Praneet Sah (2016) Design and Theory for Creating Hover Board. Int J Adv Innovat Thoughts Ideas 3:162. doi:10.4172/2277-1891.1000162
Copyright: © 2016 Praneet S. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
Hover board can be confused with a Segway but a real hover board is one that can float in air and move around. Despite huge interest from people and much technological advancement, we have not been able to invent a fullyfledged Hover board yet that could levitate and work on most of the surfaces. Although we have been able to levitate stuff (using Maglev or Super-Conductors) but in doing that in a small, portable and feasible form factor has not been quite possible yet. Few companies tried creating a Hover board but they are limited to work only on metallic surfaces and as a matter of fact, we do not get to see roads getting paved out of metals anywhere. This paper proposes a way and design on harnessing the power of pressurized vapour that would be enough to generate a lift which could levitate most of you on the Hover board and if you could balance it, you can ride it. There exist numerous implications for this theory and Hover board is just the one of best example out there.