Research Article
Single Drop Microextraction Analytical Technique for Simultaneous Separation and Trace Enrichment of Atrazine and its Major Degradation Products from Environmental Waters Followed by Liquid Chromatographic Determination
Alula Yohannes1, Tesfaye Tolesa1, Yared Merdassa1,2 and Negussie Megersa1*
1Department of Chemistry, Addis Ababa University, PO Box 1176, Addis Ababa, Ethiopia
2Department of Chemistry, Jimma University, PO Box 378, Jimma, Ethiopia
- *Corresponding Author:
- Negussie Megersa
Department of Chemistry, Addis Ababa University
PO Box 1176, Addis Ababa, Ethiopia
Tel: +251111243300/+251111239466
Fax: +251111239470
E-mail: megersane@ yahoo.com (or) negussie.megersa@aau.edu.et
Received date: July 18, 2016; Accepted date: July 25, 2016; Published date: August 01, 2016
Citation: Yohannes A, Tolesa T, Merdassa Y, Megersa N (2016) Single Drop Microextraction Analytical Technique for Simultaneous Separation and Trace Enrichment of Atrazine and its Major Degradation Products from Environmental Waters Followed by Liquid Chromatographic Determination. J Anal Bioanal Tech 7:330. doi:10.4172/2155-9872.1000330
Copyright: © 2016 Yohannes A, et al. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
Abstract
In this work, a method of single drop microextraction (SDME) combined with high performance liquid chromatography (HPLC) with diode array detection (DAD) was studied for trace level enrichment as well as simultaneous determination of atrazine (ATZ) and its major degradation products such as desethylatrazine (DEA) and desisopropylatrazine (DIA) in environmental waters. The main factors influencing the extraction procedure including types and volume of extraction solvent, sample stirring rate, sample solution pH, extraction temperature, extraction time, and salting out effect were optimized. The method detection limits were as low as 0.01 for ATZ and 0.05 for both DIA and DEA, with coefficients of determination better than 0.998 within a linear range of 0.5-150 μg L-1. Under the optimal conditions, the proposed method was applied for the analysis of real water samples and good spiked recoveries in the range of 65.6%-96.3% with relative standard deviation of less than 5% were obtained. The results confirmed that the proposed procedure provides reliable precision, linearity and sensitivity and is very effective for analyzing the target compounds in environmental waters. Therefore, the developed SDME method coupled with HPLC-DAD was found to be simple, inexpensive, and environmentally benign sample pretreatment technique.